Fax:0757-86798148
Aftermarket:0757-86795444
Q Q:1477182165
1.The electroplating industry: suitable for the electroplating of gold, silver, rare metal, nickel, zinc, tin, chromium and alloy etc.
2.Electric processing industry: removal process using electrochemical machiningdissolved anode electrode, commonly used for machining high hardness, withelectric spark machining efficiency and improve a lot.
3.Electro polishing deburring industry: electric polishing and deburring industry ispulsed power applications, the main reason is that the common DC power supplycan not be dead or deburring polishing a workpiece, when the use of single pulseoff time is conducive to a process of concentration reduction between the surfaceand the solution, the elimination of polarization, conducive to the dead anglepolishing. And according to the workpiece processing has the pore generally use double pulse power supply is better.
4.Other electrolytic polishing, anode oxidation and other demanding industry.
Pulse power supply with single pulse and double positive, negative pulse power,modulation technique using a unique, digital control.
Positive pulse open width (T+) and negative pulse width (T-) opening time can be adjusted respectively in the whole period. Forward current, voltage regulation,negative current, voltage can be adjusted independently. When the current is turned on, the pulse (peak) several times the current equivalent to an ordinary DCcurrent or even several times, it is the instantaneous high current density in themetal ion reduction potential under high, so that the grain fining; when the currentis turned off, the cathode area near the discharge and return to the initialconcentration, the concentration polarization is eliminated, the next pulse period tocontinue to use the high pulse (peak) current density, at the same time off period is also accompanied by recrystallization, favorable to the deposition layer adsorption desorption phenomena.
1.More detailed than common electroplating, plating finish better, more uniform and dense, high conductivity.
2.Reduce the impurity content in the coating, coating purity.
3.Reduce the concentration polarization, increasing the current density cathode,thus increasing the plating speed.
4.Reduce coating porosity, enhance the anti corrosive coatings.
5.The elimination of hydrogen embrittlement, coating to improve the physical properties.
6.To waive or reduce the use amount of additives.
7.With short circuit, open circuit, over current, over voltage, overload protectionfunction.
8.The internal circuit board using salt fog resistant acid treatment, the electronic components are not susceptible to corrosion, extend the power of life.
9.The panel is provided turn-on, turn off time range, pulse current range,convenient adjustment.
10.Pulse power supply DC power supply is more rapid than the traditional energy, is the development direction of DC power supply.
Input Voltage | Three-phase AC380V ± 10% ,50-60Hz | ||
Output Current | 0-50KA | ||
Pulse duty | 0-100% | ||
The output waveform | Square wave pulse or DC | ||
Forward Time | 5-40ms | ||
Reverse Time | 0.5-5.0ms | ||
Power factor | Full range of 0.9 or more | ||
Overall efficiency | ≥90% | ||
Regulation accuracy | ≤1% | ||
Steady flow accuracy | ≤1% | ||
Ripple factor | 5% or less | ||
Installation Site | Indoor | ||
Conditions of Use | Ambient temperature | 0~40℃ | |
Relative Humidity | 30%~85% | ||
Altitude | Below 1000m | ||
Health | 24 hours full load operation |